How to grow sugar cane in Minecraft

How to grow sugar cane in Minecraft

In this article, we are going to learn about ‘How to grow sugar cane in Minecraft‘. Sugar Cane is one of the most commonly seen plants in Minecraft. If any block is adjacent to water (either side of the block), sugarcane can be found and placed on podzol, dirt, or sand.

Sugar cane can generate naturally near water, the chances are:

  • Two blocks tall – 1118 chance.
  • Three blocks tall – 518 chance.
  • Four blocks tall – 218 chance.

In very rare cases, you will find very rare taller sugar canes growth. This happens when a sugar cane generates upon a pre-existing block containing grown sugarcane.

Sugar canes are five times more likely to generate in desert biome than others.

Uses of Sugarcane

The color of Sugar cane depends upon the biome in which it is placed. The color differs in green variants. Few of the uses of sugar cane are mentioned below:

  • Sugar cane can be used to create underwater paths due to the water displacing property that it inherits. These paths allow players to move and breathe at normal speed (if it is two blocks in height).
  • If one sugar cane is placed in the crafting table, it gives ‘Sugar‘. Sugar can later be used to make Cakes and potions.
  • If three pieces of sugar canes are placed adjacently then you can make ‘Paper‘. Paper can later be used to make Books and Maps.
  • Can craft rockets.
  • Sugar cane along with a composter gives Bonemeal.

How to grow sugar cane in Minecraft

Growing Mechanics of Sugarcane

How to grow sugar cane in Minecraft

Sugar cane can naturally grow up to 3 blocks in height (as discussed above). If you plant an additional sugar cane on the pre-existing one, it grows much taller. Some of the other growing mechanics of Sugar canes in Minecraft are:

  • Sugar cane can only be planted on
    – grass
    – dirt
    – podzol
    – and sand blocks.
  • The block must be directly adjacent to water.
  • Must not be above or diagonal with other crops.
  • Sugar canes depend on water inlet. It will break if the water source is removed in its next update.
  • Every 16 random ticks, sugar cane grows 1 block in height.
  • Sugar cane grows 1 block every 18 minutes (average).
  • Its growth rate is unaffected by the absence or presence of light.

Manual Farming Design of Sugar cane in Minecraft

It is really necessary to select the placement of sugar cane farming. When you begin, placing a sugar cane on a river-bank will be sufficient. But when you grow sugar cane in Minecraft on a larger scale it becomes difficult to balance between harvesting, compactness, and difficulty in building the farm.

Double rowed design: It is one of the easiest models of farming sugar cane. Though, it may not be efficient since you can only grow 2 canes per water block.

This design will be a good choice for semi-automatic designs which we will read in this article soon. When using this design, we recommend you to plant sugar cane using flowing water in spite of water source being available. Because if any item falls into water while harvesting it will end up at the central location.

More efficient way than Double rowed design: Been growing 4 sugar canes per water source sounds interesting right? So it is. The only drawback of this design is to walk through the water without falling. Which makes it difficult for the user to build and harvest. This limitation can be solved by placing lily pads or something similar.

Lighter blocks can be used to avoid mob spawns. In the latest update, waterlogged blocks emerged. These are easily obtained half slabs that you can place at the upper half of the blocks above or below the water block. You can use them instead of lily pads (to not interfere with their ability to sustain plant growth).

Walk slowly and sweep side to side by breaking all blocks except the bottom block of each sugar cane while harvesting. Then, continue by picking up any missed items.

Semi-Automatic Design farm designs to grow sugar canes in Minecraft

How to grow sugar cane in Minecraft

In Bedrock Edition of Minecraft, when sugar cane’s water source is removed, the sugar cane immediately breaks (These designs should still work in Java Edition, however, it will take a bit more time for the sugar cane to break).

We can create a semi-automatic farm that harvests the sugar cane using the above-mentioned principle.

Water canal design

How to grow sugar cane in Minecraft

  • As mentioned above, build the double rowed design.
  • Now, to control the water flow, place dispensers containing water buckets.
  • When we remove the water streams, the connection of water source to sugar cane blocks will break. This will cause the sugar cane to break.
  • Now, the player can pick them up and replant another sugar cane.

Piston Harvestor

This design to harvest sugar cane uses pistons.

If the sugar cane is only two blocks tall, it will most likely be pushed into the water stream. So, if we grow the sugar cane taller than two blocks, the top blocks may fall down to the sand, and the player can pick it up. You can use this design on the basis to make a fully automatic farm. Few basic changes are required, so that, even the top blocks are pushed rather than break and can prevent loss of any sugar cane.

Bone meal Design

How to grow sugar cane in Minecraft

In Bedrock Edition of Minecraft, if we use a bone meal for growing sugar cane, they instantly grow to maximum height. We will be using these mechanics to create automatic sugar can farms.

  • the dispenser must be filled with bone meal to constantly grow the sugar cane.
  • Since the bone meal is not used on a fully grown sugar cane, none is wasted.
  • Now, the player can stand and break the middle block of sugar can quickly.

This will allow the player to harvest larger quantities while the bone meal will constantly grow the sugar cane from the middle block.

You can connect a piston to make this process more automatic. A 4 game tick delay clock should be used instead of an observer clock or Redstone clock. Because pistons cannot push and collect as quickly as the observer clock. Adding to this, single hoppers may not be able to keep up with a large amount of sugar cane (using bone meal) and multiple hoppers would be required. this is why 4 game tick delay clock is an idle choice.

Fully-Automatic Design farm designs to grow sugar canes in Minecraft

By using some sort of Redstone clock or growth deduction, fully automatic designs automatically harvest and collect sugar cane. People tend to think about expense that will be required in order to build these designs. Such designs may be lag prone comparatively to other designs. In the end, the large amount of sugar cane that is harvested and produced pays off well.

There are four main types of automatic sugar cane farms:

  • Stationary;
  • Flying;
  • Sim-tick;
  • zero-tick;

Zero tick designs usually use pistons or sand manipulation. Zero-tick sugar cane farms are faster in Bedrock Edition. With some getting at or above 2,000 sugarcane per hour per plant.

Stationary design

We can convert the semi-automatic design of farming we discussed above that includes piston into a fully-automatic piston design by using a daylight sensor or other clock circuit. If you want to reduce the loss of sugarcane, we recommend adding another layer of pistons above the original layer of the piston. However, this design can be an alternative for flying machines that are in terms difficult to create and use for the purpose of farming sugar can mostly in bedrock edition.

Other variations of stationary designs are also possible, such as this diagonal design. Which uses a hopper clock rather than a daylight sensor.

Instead of using a clock, some designs use observers to harvest the sugar cane. But such designs use inefficiently more space compared to the clock method. Since the pistons activate the growth of sugar cane, these design becomes less lag efficient too. When constructing, the sugar cane falls on dirt and rails run. Placing them right at the place of a piston.

It is possible to speed up the process of sugar cane by removing the water source and replacing it in the same game tick, this process is called zero-ticking.

Flying Design

To create the most efficient farms, players can use flying machines and hopper minecarts that can be combined.

Except when harvesting, flying machine designs do not cause lag since they use a very few pistons. This design is recommended and preferred when creating large farms. The main drawback of such farms is that they may break while unloading (if the design is running). That is why supervision is suggested while running these designs.

Instead of larger fields, some flying farms focus only on individual rows of sugar cane. Designs like these typically cost fewer slime blocks to build and are usually the cheapest option for mass farming.

FAQ:

  • What’s a sugar cane in Minecraft, and where is it generally found?

Ans: Sugar Cane is one of the most commonly seen plants in Minecraft. If any block is adjacent to water (either side of the block), sugarcane can be found and placed on podzol, dirt, or sand.

  • What all are the uses of Sugarcane?

Ans: It has a variety of uses, right from making simple paper and sugar to creating underwater pathways and rockets. Read our article to know further about the uses of Sugarcane.

Conclusion

Growing sugar cane is a fun job, experimenting in building your own large farms using semi-automatic and automatic modes can make you feel exciting. Comment below and let us know which type of farm suits you best to grow sugar canes in Minecraft.

Thank you for reading this article on ‘How to grow sugar cane in Minecraft‘. If you have any queries or doubt please comment below. We will be glad to help you.

Leave a Comment

Your email address will not be published. Required fields are marked *